Bezier to Gcode: "Error when writing gcode file"

Welcome to BoardCAD forums Software BoardCAD Bezier to Gcode: "Error when writing gcode file"

  • This topic contains 1 voice and has 0 replies.
Viewing 1 post (of 1 total)
  • Author
    Posts
  • #3726

    ExtremelyCassidy
    Participant

    Hey once again!

    I came across the sweet looking feature Beizer to gcode!
    But I find very little info on how to use it, so any references would be appreciated.

    However, I get the error attached below.. what might cause it?

    Does it use the shapebot.properties file?

    Kind regards,
    Cassidy

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.