G-code crossing over and leaving rails dry?

Welcome to BoardCAD forums Software BoardCAD G-code crossing over and leaving rails dry?

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #4817

    ExtremelyCassidy
    Participant

    Hi Guys!

    I’m encountering a bit on an odd problem on some of my gcode lately. The bottom toolpath is overlapping in the centre, which i believe is causing the rail to have a quite noticeable uncut area.

    Have a look at the photos below.

    Attachments:
    You must be logged in to view attached files.
    #4820

    pete_w
    Participant

    Assuming you are using a bullnose cutter then at the tail looks expected because you have a concave leading to a sharp corner. So it will be offset the tool towards the centre of the board to cut with the outer part of the radius.

    At the nose I suspect maybe a concave thing again, its hard to say without the model. Send it thought if you are still having problems.

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.